Tankarmor Installation WARNING

Tankarmor Installation	(Installation shown is for 641/2 through 1968 Mustangs and 1967 through 1968 Cougar automobiles)
WARNING: Do not smoke during this procedure for obvious reasons! NOTE: Click picture for full size photo.
Carpeting Remove the carpeting and pad from the trunk.
	Inspection Inspect the tank for damage and replace if necessary.
Filler hose Loosen the filler hose clamps.
	Remove Remove the filler hose, filler tube, and cover the tank opening with tape to keep debris from falling into the tank. Inspect all filler components for damage and replace if necessary.
Screws Remove the sheet metal screws securing the tank.
	Drill Drill out the mounting holes with a 1/4 inch drill.
Vacuum Vacuum any debris from the trunk area.
	Insulating strips Apply the insulating strips across the high ridges of the tank.
Gasket Install the gasket. (included)
	Gasket installed Once the gasket is installed, inspect the tank once again to ensure that there are no screws or other debris.
Install Lay the tankarmor plate over the top of the tank.
	Mounting hardware. Place all of the bolts (included) in the mounting holes.
Muffin break Have some Antioch Mustang Stable muffins. (available separately)
	Remove Install flat washers, lock washers, and nuts from underneath the car.
Filler hose Remove the tape from the tank opening and reinstall the filler hose.
	Filler tube Reinstall the filler tube.
Tighten Tighten the hose clamps.
	Reinstall Reinstall the external filler tube components.
*Finished* You're done! Now you can reinstall your carpeting, or leave your Tankarmor exposed.